FloPlast Push Fit Waste Socket Plug - 32mm Black
This socket plug is used to gain access into the waste system for inspection and cleaning. Often referred to as a cleaning eye, it is most commonly installed into a waste tee. Socket plugs can also be used to blank off an unused connection or pipe run.
This fitting is available in 32mm, 40mm and 50mm size options, with 50mm only available in grey.
This push fit waste system is manufactured in the UK to BS EN 1451 and is British Standard kitemarked.
When making a push fit joint, cut the pipe square and remove any burrs, push the pipe into the fitting as far as it will go and then withdraw it by approximately 10mm to allow for any expansion. The joint can be taken apart again if required, but always check that the O ring has not been dislodged from its housing groove in the fitting as this will cause the joint to leak.